A strong base (caustic or alkali) is added to oils to test for: b. entrained air a) - alkalinity b) - acidity c) - contamination. d) - stability
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “A strong base (caustic or alkali) is added to oils to test for: b. entrained air a) - alkalinity b) - acidity c) - contamination. d) - ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
A resistor, inductor and capacitor are connected in series, each with effective (rms) voltage of 65 V, 140 V and 80 V, respectively. If the resistor is rated at 24 W, what is the average power dissipated in the circuit
Answers (1)
Technician A says that as wheelbase becomes shorter in a highway truck, its resistance to yaw is reduced. Technician B says that an ABS add-on called directional stability control uses the brake system to avoid tracking yaw. Who is correct?
Answers (1)
You just realized the turn signal on your vehicle is broken, and you need to signal that you're turning left. What is the correct way to do it?
Answers (2)
A rigid tank initially contains 1.4 kg saturated liquid water at 200∘C. At this state, 25 percent of the volume is occupied by water and the rest by air. Now heat is supplied to the water until the tank contains saturatd vapor only.
Answers (1)
For the following conditions determine whether a CMFR or a PFR is more efficient in removing a reactive compound from the waste stream under steady-state conditions with a first-order reaction: reactor volume = 280 m3, flow rate =
Answers (1)
New Questions in Engineering
Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.
Answers (1)
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)