Sign In
Ask Question
Engineering
Joslyn Galvan
4 February, 15:59
List irreversibilities
+3
Answers (
1
)
Caitlyn Herring
4 February, 17:51
0
Some of the irreversibilities are listed below:
Plastic deformation of solids Transfer of heat over finite difference of temperature When two fluids are mixed together the process is irreversible Combustion of a gas Current flowing through a finite resistor Diffusion and free compression or expansion of gas Relative motion of body with force of friction Processes involving chemical reactions (spontaneous)
Comment
Complaint
Link
Know the Answer?
Answer
Not Sure About the Answer?
Get an answer to your question ✅
“List irreversibilities ...”
in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
A budding electronics hobbyist wants to make a simple 1.0-nF capacitor for tuning her crystal radio, using two sheets of aluminum foil as plates, with a few sheets of paper between them as a dielectric. The paper has a dielectric constant of 3.
Answers (1)
What is the governing ratio for thin walled cylinders?
Answers (1)
What is the net force acting on a car cruising at a constant velocity of 70 km/h (a) on a level road and (b) on an uphill road?
Answers (1)
Consider the flow past a 30-degree expansion corner. The upstream conditions are M1 = 2, P1 = 3 atm, and T1 = 400 K. Calculate the following downstream conditions: M2, P2, T2, T02, and P02.
Answers (1)
Just upstream of a shock wave, the air temperature and pressure are 288 K and 1 atm, respectively; just downstream of the wave, the air temperature and pressure are 690 K and 8.656 atm, respectively.
Answers (1)
New Questions in Engineering
Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.
Answers (1)
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)
Home
»
Engineering
» List irreversibilities
Sign In
Sign Up
Forgot Password?