Ask Question
EngineeringEngineering
16 December, 06:02

In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False

+5
Answers (1)
  1. 16 December, 09:49
    0
    The given statement is True

    Explanation:

    Solid motor uses plasticizers out of which Poly Butadiene Acrylic Acid acrylo Nitrile (PBAN) and Hydroxy Terminator Poly Butadiene (HTPB) are the most commonly used. These are used in space shuttles.

    PBAN is comparatively stick, thick and it has a stinky smell as compared to HTPB. PBAN can be mixed and cured at high temperastures few days later wheras HTPB can be mixed and cured at room termperatures within a day.

    The propellant can be ready to use for flight a day later.
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
g In the above water treatment facility, chemical concentration (mg/gal) within the tank can be considered uniform. The initial chemical concentration inside the tank was 0 mg/gal, the concentration of effluent coming in is 10 mg/gal.
Answers (1)
The concrete canoe team does some analysis on their design and calculates that they need a compressive strength of 860 psi. They test several mix designs and chose one that has a sample mean of 900 psi with a standard error of the mean of 10 psi.
Answers (1)
For the following conditions determine whether a CMFR or a PFR is more efficient in removing a reactive compound from the waste stream under steady-state conditions with a first-order reaction: reactor volume = 280 m3, flow rate =
Answers (1)
When it has been determined that an AC system has a low refrigerant charge what should be done
Answers (1)
Write an expression for the output voltage of an AC source that has an amplitude of 19 V and a frequency of 240 Hz. (Use the following as necessary: t. Assume V is in volts and t is in seconds. Do not include units in your answer. Assume V
Answers (1)
New Questions in Engineering
Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.
Answers (1)
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)
Home » Engineering » In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Sign Up Forgot Password?