Which dot plot has the greatest number of observations?

Explain the process of predicting equipment failure?

A ring-shaped seal, made from a viscoelastic material, is used to seal a joint between two rigid pipes. When incorporated in the joint, the seal is held at a xed compressive strain of 0.2.

A particle is emitted from a smoke stack with diameter of 0.05 mm. In order to determine how far downstream it travels it is important to find its terminal downward velocity.

In normal operation, a paper mill generates excess steam at 20 bar and 400◦C. It is planned to use this steam as the feed to a turbine to generate electricity for the mill.

A water pump increases the water pressure from 15 psia to 70 psia. Determine the power input required, in hp, to pump 1.5 ft3/s of water. Does the water temperature at the inlet have any significant effect on the required flow power?

Which is the correct order for handwashing

You built an android that has a subcircuit containing a power supply, a tactile sensor, and a fuse where safe operation should keep current below 250 mA. You measured that your sensor is dissipating 12 W, the power supply is pro - viding 12.

The electronics aboard a certain sailboat consume 50 W whenoperated from 12.6-V source. If a certain fully charged deep-cyclelead acid storage battery is rated for 12.

The water behind Hoover Dam in Nevada is 221 m higher than the Colorado River below it. At what rate must water pass through the hydraulic turbines of this dam to produce 50 MW of power if the turbines are 100 percent efficient?

Why is it important to cut all the way through an electrical wire on the first try?