Physics

Houston Ho

25 May, 14:35

Sally Sizzle builds a circuit by connecting three resistors in parallel with a 9V battery. The current in this circuit is 3.6 amps. Sally wants to add another resistor in parallel to increase the current to 4.6 amps. What should the resistance of this new resistor be? A) 0.5 Ohms B) 5 Ohms C) 9 Ohms D) 10 Ohm

+2

Answers (1)

Know the Answer?

Not Sure About the Answer?

Get an answer to your question ✅ “Sally Sizzle builds a circuit by connecting three resistors in parallel with a 9V battery. The current in this circuit is 3.6 amps. Sally ...” in 📙 Physics if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.

Search for Other Answers

You Might be Interested in

Two planes take off from the same airport at the same time using different runways. One plane travels on a bearing Upper S 14 degrees Upper W at 440 miles per hour.

13.1 A steel ball of radius 2.45 cm fits through the middle of an aluminum ring of radius 2.46 cm when the temperature is 20o c. a. For what temperatures will the steel ball no longer fit through the ring? b.

What is diffraction?

A helicopter is traveling at 86.0 km/h at an angle of 35° to the ground. What is the value of Ax? Round your answer to the nearest tenth. km/h

How much rope would need to be pulled through a pulley with a mechanical advantage of 2 to lift a load 4 ft?

New Questions in Physics

A heating pad has several strips of heater wire connected in parallel. Consider eight of the wires, each with 4Ω resistances, connected to a 12V power source. given this scenario answer the following questions A.

Who first arranged the elements according to atomic mass and noticed a periodic recurrence of their physical and chemical properties? A. Henry Moseley B. Antoine Lavoisier C. John Dalton D. Dmitri Mendeleev

If the road is wet the thinking distance will be longer. True or false. Why?

You are working on a curcuit that starting to get too much current. What could you do to slow down the electron flow? A) add more watts B) increase resistance C) increase voltage D) add more volts

A 242-g block is pressed against a spring of force constant 1.62 kN/m until the block compresses the spring 10.0 cm. The spring rests at the bottom of a ramp inclined at 60.0° to the horizontal.